Product Details

Product introduction

According to GB4208-2008 "Shell Protection Code", GB7000.1-2007 "Lamps Part 1 General Test and Requirements"

Features

1. The simulated immersion depth is 0~30M;

2. The size of the tank liner is Ø1000mm*1000mm (H); (or customized according to the maximum sample size provided by the customer)

3. The water immersion pressure vessel is made of stainless steel;

4. The depth of immersion is adjustable according to the size of the product, and the outside can be observed;

5. Closed container design, applying pressure of 0~3 atmospheres with compressed air; (customer-supplied, or optional)

6. Using intelligent sensors to sense water pressure data and feed back to custom instruments

7. The atmospheric pressure value is displayed by special instruments;

8. Working gas source: external;

9. Optional 2-point temperature meter to record water temperature

10. Working power supply: 220V, 50Hz

Installation requirements

The installation site should have a water source;

The installation site should have compressed air, pressure ≥ 5kg / cm2;

Installation site area: 2*2(m);

Installation site power: 220V 50Hz;

The installation site must have a drain;

The distance between adjacent walls or objects should have 1M space before and after;

The ambient temperature of the installation site should not change drastically;

Should be installed on a level surface;

It should be installed in a place without direct sunlight;

It should be installed in a well ventilated place;

Should be installed away from combustibles,

A place where explosives and high-temperature heat sources are used;

Should be installed in places with less dust;

Install as close as possible to the power supply.

Environmental conditions: temperature 5~25°C relative humidity ≤85%R H